Yes, adding perlite without repotting works. A few surface tricks let you push perlite into the soil and help water drain faster, without ever lifting the plant out. Mixing perlite in fully during a repot is still the best version of the fix. That way it reaches the whole pot, from the surface down to the deepest roots.
A bamboo chopstick sat by my pothos on the south-facing windowsill, so I grabbed it. The soil had gone hard and gray, and water pooled on top for a full minute before it sank. I poked a dozen holes into that crust and dribbled dry perlite down into each one. Then I tapped the pot on the sill to settle the white beads in deep. Two days later I checked it, and the water vanished in seconds. The pothos pushed out a fresh leaf by the end of that same week. I tried the same chopstick fix on a tired peace lily right after, and it perked up by the next watering too.
Top dressing perlite is the gentlest place to start. You scatter a thin layer across the surface, about a half inch deep, and leave it sitting there. Each time you water, a little perlite washes down into the soil below. It is slow, but it asks nothing of the roots. This makes it a safe pick for a plant you would rather not disturb at all.
Poking holes works much faster when you need to improve soil drainage in a hurry. Grab a chopstick or a pencil and make holes through the top few inches, about 5 to 8 cm deep. Then funnel perlite straight down into them and tamp it lightly. Stay near the pot edge so you miss the main root ball. You can also scratch a handful into the surface around the stem with your fingers. That breaks the hard crust so water moves through it again.
Here is the catch that every surface method shares. They only fix the layer you can reach. The deep root zone keeps its old, packed soil and its old drainage, since perlite added from the top rarely sinks more than an inch or two on its own. So the bottom half of the pot can still hold water far too long, even after the surface drains fine. That soggy zone is where roots rot first, well below where any chopstick ever reaches.
These tricks buy you real time and real relief. For a plant that is just a little tired, they may be all you ever need. A badly compacted or root-bound plant is a different story. The soil has set into one dense brick, and the roots circle the inside of the pot. For that plant, a full repot with perlite blended through the whole mix is the lasting fix. Aim for about one part perlite to three parts soil so the entire root zone gets air, down low where it counts. Do the surface trick now to steady the plant. Then plan the repot for spring when growth picks back up.
Watch the plant for a week after any surface fix and let it tell you what to do next. If the top dries out at a healthy pace and new growth appears, the simple method did its job. If water still sits and the lower leaves yellow, the deep soil is the problem and only a repot reaches it. Perlite never breaks down, so whatever you add now keeps working for years, whether you sprinkle it on top today or fold it through fresh mix later.
Read the full article: Perlite for Plants: A Complete Guide