Is tap water OK for spider plants?

picture of Vo Thanh
Vo Thanh
picture of Malcolm Reeves
Malcolm Reeves
Published:
Updated:

A full watering can sat on my counter overnight. It rested beside the variegated Vittatum in its east-window hanging basket. By morning the sharp chlorine smell was gone. The new leaves I fed it stayed green at the tips. Tap water spider plants drink is usually fine, but it can brown the leaf tips when your supply is fluoridated or hard.

Spider plants have a real fluoride sensitivity, more than most houseplants. The fluoride your city adds to drinking water is good for teeth. It is rough on these leaves, though. It builds up in the soil over weeks and burns the tips a dry brown. So your water can look clean and still do the damage. The browning starts small at the very tip. Then it spreads back along the leaf if you keep using the same water. A few thin strips of dead tissue are the first warning sign.

Salts and chemicals are the other half of the story. Tap water carries soluble salts, chlorine, and minerals. These do not leave when the water dries. They stay in the potting mix and grow stronger each time you water. The roots pull up that salty water. The plant pushes the excess out to the leaf tips, where it scorches the tissue brown. You may even see a white crust on the soil surface or around the pot rim. That crust is the salt left behind, and it is a clear sign the mix is loaded.

The good news is that water choice is an easy fix. Not every option costs money, either. Some homes have soft water and never see a problem at all. Others sit on a hard or fluoridated supply and need a swap. You can check your own water report online to see if fluoride is added. Here is how the common choices stack up for the tap water spider plants get at home.

Best Water Options Ranked
Rainwater
Best, naturally soft
Distilled water
Best, no fluoride or salts
Tap left out 24 hours
Good, chemicals evaporate
Plain fluoridated tap
Risky, can brown tips

Start with the cheapest move. SDSU Extension suggests setting tap water out for 24 hours before you use it. The rest period lets chlorine and some other chemicals evaporate into the air. That is the overnight change I noticed with my own can. This alone clears up brown tips for a lot of growers. It costs you nothing but a little planning the night before.

If the tips keep browning after that, your water is likely fluoridated or hard. Resting it will not strip out fluoride or salts. UF/IFAS recommends rainwater or distilled water for plants that react to fluoride. Spider plants sit right at the top of that list. Set a clean bucket outside during a storm. Or grab a jug of distilled from the grocery store for a few dollars and keep it under the sink.

One more habit protects you no matter which water you pick. Flush the soil every couple of months. Run plain water through the pot until it pours freely out the drainage holes. This washes out the built-up salts before they reach a level that burns the leaves. Skip this step and even good water will leave a slow buildup behind over a year. The flush takes two minutes at the sink.

Brown tips can come from low humidity and over-feeding too. The main guide covers that full list. For the water question alone, the answer is simple. Use rested tap water first. Switch to rainwater or distilled if tips still brown. Flush the pot now and then. Do those three things and the new growth on your spider plant stays green right to the point.

Read the full article: Spider Plant Care: Complete Guide

Continue reading